|
||||||||
|
||||||||
| The pneumatic machine TP/LN-100 is used for cutting the leads of loose radial components. |
|
| It was designed to adapt to a very wide range of radial parts. The upper stationary plate determines the cutting height; the standard is 3.2mm Additional plates to increase the height can be supplied upon request starting from 0,5mm. The pneumatic foot pedal performs a quick cut of the leads, without any stress to the components. The plates have a standard grid pattern, to accommodate most types of components. Plates with a special grid pattern can be provided upon request. The unit lateral cuts most common pitches to allow easy handling of warped leads. Note:- Minimum Plate Thickness 2.4mm (Smaller by selective milling on the top plate) |
|
|
MM
|
INCH
|
|
||||||||||
|
|
|
||||||||||
|
** Note Fixed Plate thickness - 3.2mm Other sizes on request |
||||||||||||
|
TECHNICAL DATA
|
 |
|
 |
Series 4 Limited / Wire
Stripping / Copyright © Series 4 Limited 1995 ~ 2008
Tel +44 (0)23 8086 6377 Fax +44 (0)23 8086 6323
Series 4 Web Site:- http://www.series4.co.uk
Series 4 Sales Email:- sales@series4.co.uk
Data Sheet TP/LN100
can be found by clicking the following link :-
http://www.series4.co.uk/prodeqpt/section25/ds78.htm
