CARPENTER 96/97
BLADE CALIBRATION

 ORDERING
INFORMATION

Click here to go to this
product data sheet

1.  Turn machine off

2.  Make sure there is no wire in the machine.

3.  Remove INPUT and EXIT GUIDE TUBES

4.  Open up the right hand set of rollers as far as possible.

5.  Hold down and keep holding the LOAD WIRE key while turning on machine.

6.  Press RUN key to start blade movement.

7.  Press STOP key when you observe no overlap of blades (i.e. when the light disappears when the blades close) it may be useful to have a small torch shining on the blades from the input guide side.

Note if you did not manage to do this correctly the first time press the RUN key again to restart the procedure.

8.  Press ENTER

9.  Reinstall INPUT and EXIT  GUIDE TUBES