DATA SHEET 113
  D2 - MANUAL LEVER MULTICORE STRIPPER
MULTICORE STRIPPING OUTER & INNERS IN ONE OPERATION

 
A quick and simple solution to multicore stripping suitable for production wire stripping.

By a single pull on the handle precision die blades strip off the outer jacket and secondary blades strip the inner conductors to preset dimensions.

The D2 is effective with PVC, neoprene, rubber and comparable insulations.


Exploded Diagrams
Click Here

 

Simple Set Up & Operation


The outer jacket is stripped by selecting the nearest size of outer jacket die blades from the four position die blade set and setting the rear length stop to the correct strip length.

The outer jacket blade holder is adjustable for cable diameter variations.

As the outer jacket is stripped the inner conductors are drawn through a set of pinch rollers which hold them in position for stripping by a set of flat blades in the secondary stripping operation.

These blades are also adjustable for conductor diameter and are set to operate at the required position by adjustment of a cam operating lever.

Once set the cable can just be laid into the unit and with a single pull of the handle outer jacket and inner conductors are stripped with a cycle time of a few seconds.

The 3 stages of the stripping process can be seen below:
 

  The outer jacket is stripped in the first stage of the operation by the outer stripping blades.   In stage 2 of the stripping process the rollers align the inner cores ready for stripping.   In the final stage, the inner blades close and remove the insulation cleanly from the cores.


Special blades for flat, oval and non-standard conductors are also available.

By simply disabling the secondary stripping function the D2 can be used as an outer jacket stripper only.




 

TECHNICAL DATA

CABLE DIAMETER RANGE

 :

3 ~ 10mm OD - Up to 7.5mm Core Size

STANDARD BLADE SET HOLE SIZES

 :

3mm, 4mm, 5mm & 6mm - Up to 7.5mm Maximum Speicals

SPECIAL BLADE SETS

 :

Normally within 24hours - contact Series 4 directly

SIZE 

 :

380mm x 275mm x 120mm

WEIGHT

 :

4.25kg Net (4.75kg Gross) Box Dimensions 470mm x 320mm x 220mm
MAXIMUM OUTER JACKET STRIP : 165mm (Longer if no inner strip required)
MACHINE WARRANTY : 12 Months

 


Series 4 Limited / Wire Stripping / Copyright © Series 4 Limited 1995 ~ 2008
Tel +44 (0)23 8086 6377    Fax +44 (0)23 8086 6323
Series 4 Web Site:-  http://www.series4.co.uk
Series 4 Sales Email:- sales@series4.co.uk


 

 

 

 

 

Data Sheet D2
can be found by clicking the following link :-
http://www.series4.co.uk/prodeqpt/section03/ds113.htm